Information presented in this brochure is for informational purposes only. Link Engineering Company reserves the right to make changes, alterations and substitutions to the machines, components or other information presented in this brochure without prior notice. For the latest information contact Link Engineering Company. Equipment pictured in this brochure may be shown with safety equipment removed or disabled for purposes of illustration. Equipment must never be operated with safety equipment removed or disabled.
Information presented in this brochure is for informational purposes only. Link Engineering Company reserves the right to make changes, alterations and substitutions to the machines, components or other information presented in this brochure without prior notice. For the latest information contact Link Engineering Company. Equipment pictured in this brochure may be shown with safety equipment removed or disabled for purposes of illustration. Equipment must never be operated with safety equipment removed or disabled.
Low Pressure Wear Test Machine
Model 1450
System Features |
- Variable speed controller
- Motor position adjustment capability
- Adjustable sample holder
- Digital pressure controller (pneumatic)
- Programmable Timer
- Dial Indicator
- Test bench with guard
|
The LINK Model 1450 Low Pressure Wear Machine is designed to generate accelerated rotor wear with the application of low-pressure drag, simulating rotor kindness and wear characteristics representative of off-brake operation.
A fixture holds the friction sample parallel and flat to the rotor without vibration and the sample is centered for mid-radius alignment at a twelve o’clock position. The apply operation system is capable of pressures up to 1 Bar. Test speed is at the equivalent rpm of 113 kph and test environment is at ambient conditions.
The motor is mounted to allow adjustment for adaptation to various rotor thickness sizes, while the sample fixture allows adjustment for different rotor diameters. A dial indicator is utilized for test setup. Typical methods for final inspection are micrometer measurement and surface finish.
Information presented in this brochure is for informational purposes only. Link Engineering Company reserves the right to make changes, alterations and substitutions to the machines, components or other information presented in this brochure without prior notice. For the latest information contact Link Engineering Company. Equipment pictured in this brochure may be shown with safety equipment removed or disabled for purposes of illustration. Equipment must never be operated with safety equipment removed or disabled.
