Information presented in this brochure is for informational purposes only. Link Engineering Company reserves the right to make changes, alterations and substitutions to the machines, components or other information presented in this brochure without prior notice. For the latest information contact Link Engineering Company. Equipment pictured in this brochure may be shown with safety equipment removed or disabled for purposes of illustration. Equipment must never be operated with safety equipment removed or disabled.
Information presented in this brochure is for informational purposes only. Link Engineering Company reserves the right to make changes, alterations and substitutions to the machines, components or other information presented in this brochure without prior notice. For the latest information contact Link Engineering Company. Equipment pictured in this brochure may be shown with safety equipment removed or disabled for purposes of illustration. Equipment must never be operated with safety equipment removed or disabled.
Portable Roller Brake Tester
Model 20200
System Features |
- Reduces operating costs and improves safety
- Rapid and simple testing
- Accurate, objective, and repeatable brake system analysis
- Test ABS and ATC automatically
|
The Model 20200 Portable Roller Brake Tester measures brake forces at each wheel with strain-gage type transducers that can be dead-weight calibrated quickly in-place. This is the same equipment used by state enforcement and OEM. It is simple to use and brakes on a five-axle tractor trailer can be checked in only 5 to 10 minutes total. This includes the following measurements at each wheel:
- Rolling Resistance - detects dragging brakes that consume brake linings and fuel
- Brake Threshold Pressure - determines if all brakes start working at the same pressure level
- Service Brake Force - checks proper function. Finds defective brakes, oil-soaked linings, etc.
- Parking Brake Force - finds weak or broken spring brakes, bad valves and other defects
- ABS/ATC Operation - automatically checks sensors, valves and wiring.
The tester can be placed on a garage floor or parking lot and does not require a special foundation or pit. It is only 6 inches high above the rollers. Just plug in the power cord and the tester is ready to run. When not in use, ramps quickly fold up so that the unit is only 3 feet wide. With optional casters and dolly, one person can easily raise the unit and roll it out of the way.
Information presented in this brochure is for informational purposes only. Link Engineering Company reserves the right to make changes, alterations and substitutions to the machines, components or other information presented in this brochure without prior notice. For the latest information contact Link Engineering Company. Equipment pictured in this brochure may be shown with safety equipment removed or disabled for purposes of illustration. Equipment must never be operated with safety equipment removed or disabled.
